Beissbarth MT ZERO 6 Touch Betriebsanleitung Seite 142

en 142 | MT ZERO 6 Touch | Faults
12. Faults
i
Other possible malfunctions are primarily of a technical nature and are to be checked and if necessary rectified
by a qualified engineer. Always contact the customer service of your authorized Beissbarth equipment dealer.
i
For rapid assistance, it is important to provide the information on the rating plate (label on MT ZERO 6 Touch)
and describe the nature of the problem when calling.
!
If the error message persists, contact customer service.
Error Causes
R Defective fuse or missing phase.
When the
R Damaged fuse in electrical connection.
machine is
started up, the R Damaged fuse on the CPU card.
monitor does
not switch on
The pneumatic Solenoid valve defective.
flange is not
released when
the pedal is
actuated
R Setting and calibration data lost from circuit board
ERROR 1
memory.
R One or more calibrations (setting, calibration of
electronic rim-distance gauge/sonar) were not carried
out.
ERROR 2 Wheel-guard hood raised prior to completion of
measurement.
R Wheel rotates backwards on start of measurement.
ERROR 3
R Incorrect connection of motor.
R No motor operation. The motor is not reaching the
ERROR 4
required speed.
R Fault in electrical connection.
R Fault on circuit board.
ERROR 5 R Balance weight not attached to wheel.
R Measurement sensors not correctly connected.
R Wheel-guard hood not lowered.
ERROR 6
R Damage to wheel-guard hood safety switch.
ERROR 7 Excessive phase difference between the 2 measurement
sensors.
ERROR 8 Inner measurement sensor not correctly connected,
defective or open circuit in wire.
ERROR 9 Outer measurement sensor not correctly connected,
defective or open circuit in wire.
R Measurement sensor for position recognition
ERROR 10
defective.
R No motor operation.
R Measurement sensor for phase recognition defective.
ERROR 11
R No motor operation.
ERROR 17 Weight outside setting range (weight required for
balancing is more than 250 g).
ERROR 18 Rim data not entered.
ERROR 19 Input signal of right measurement sensor lower than that
of left sensor.
R Pedal pressed during measurement.
ERROR 20
R Irregular rotational speed of motor.
R Wheel speed below minimum value.
ERROR 21 The circuit board has detected an excessively high wheel
speed with the wheel-guard hood open (shaft rotating at
high speed without the MT ZERO 6 Touch having been
started): power supply unit deactivated.
|
1 695 600 965 2020-02-27
Remedy
Check the power connector.
Inform customer service.
Caution: repeated fuse damage is an indication of a
malfunction!
Follow the emergency procedure for releasing the wheel
(see sec. "Wheel removal in the event of faults").
Inform customer service.
Wait for end of measurement before raising wheel-guard
hood.
Check that wheel is stationary when starting and stop it
from turning backwards on starting.
R Check the voltage (probably too low).
R Check the electrical connection or power supply
cable.
Repeat calibration from the start and attach balance
weight as specified by the process (see chapter
"Maintenance"
Inform customer service.
Lower wheel-guard hood with wheel attached.
Inform customer service.
Inform customer service.
Inform customer service.
Inform customer service.
Inform customer service.
Check whether the wheel is correctly attached to the
flange.
Enter rim data before performing measurement.
Inform customer service.
R Do not press pedal while motor is in operation:
R Make sure the MT ZERO 6 Touch is not subjected to
any impact during measurement.
R Check the voltage (probably too low).
R Switch off the MT ZERO 6 Touch.
R Lower wheel-guard cover, switch the
MT ZERO 6 Touch on again without moving the wheel.
Inform customer service.
Beissbarth GmbH