Beissbarth MT ZERO 6 Touch Betriebsanleitung Seite 114

en 114 | MT ZERO 6 Touch | Wheel balancing
4. Position the electronic rim distance gauge at
the 3nd measurement point (without previously
moving the electronic rim distance gauge to its rest
position), and keep it in that position for 1 second.
ALU2
Fig. 69: 3rd measuring point and 2nd balancing plane for ALU2
 An acoustic signal will confirm that the position
has been acquired.
Fig. 70: Showing the 3rd measurement point for ALU2
i
If the electronic rim distance gauge is returned to
its rest position, the data collection screen will be
shown and the ALU2 balancing program will be
selected automatically.
i
Automatic selection of the balancing program is
activated following use for the first time. To activate
it, select the "Machine settings" menu and change
the status of the following symbols.
Green: Automatic acquisition of the dimensions
and the balancing program by the electronic rim-
distance gauge and the sonar probe active.
Green: Automatic selection active.
|
1 695 600 965 2020-02-27
8.7 Acquiring rim data automatically
After automatic program selection, the data collection
screen with the values measured in the previous phase
and the positions of the weights based on the required
balancing program will open automatically.
Fig. 71: Example of a data collection screen
Symbols Description
Distance between the rim and the wheel
balancing machine
Rim width
Rim diameter
Manual balancing program selection
After the symbol has been pressed with the
protective hood lowered, the start for the
imbalance measurement will be activated.
i
The data collected can be changed manually.
i
After the electronic rim distance gauge has been
removed, the screen for automatic balancing
program selection will be shown again. That way,
the dimensions can be measured again.
Proceed as follows to change the value of a parameter:
1. Tap the numerical value to be changed.
 A numerical evaluation device will be displayed.
Fig. 72: Numerical evaluation device
Beissbarth GmbH