Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Symbols Description
"0-9" "."
Digits and symbols for specifying the desired value
"C"
Resets the value displayed on the monitor to zero
When tapped, deletes one digit from right to left
Confirms the value entered and returns to the data
collection screen
"mm"
When tapped, converts the numerical value entered
"inch"
into the desired unit
2. Enter the desired value by tapping the symbols on
the monitor.
i
The values for rim distance and width can be set to
any "inch" or "mm" value.
3. The unit can be changed as required.
4. Confirm the value entered to return to the data
collection screen.
8.7.1
Standard, ALU1 (PAX1), ALU4, ALU5 and all
static balancing programs
Fig. 73:
Example of a data collection screen for static balancing
programs
Distance and rim diameter
After the automatic selection of the balancing program,
all input boxes will be automatically filled in.
i
If the measured data needs to be changed, tap the
parameter value to display the numerical evaluation
device.
Rim width
i
The rim width can be measured electronically by
sonar for the standard programs.
See the "Technical data" section for specifications
on the sensing range of the sonar probe.
Beissbarth GmbH
Wheel balancing | MT ZERO 6 Touch | 115
i
The data is automatically collected when the
wheel guard is lowered to activate the start of the
imbalance measurement or when the
tapped while the protective hood is already closed.
The input box will be gray to indicate that the data has
not yet been collected.
i
The data present before the protective hood has
been lowered does not refer to the wheel currently
attached.
8.7.2
ALU2 (PAX2) and ALU3
Fig. 74:
Example of a data collection screen for ALU2 programs
Distance, rim diameter and rim width
After the automatic selection of the balancing program,
all input boxes will be automatically filled in.
i
If the measured data needs to be changed, tap the
parameter value to display the numerical evaluation
device.
8.8
Manual balancing program selection
The balancing program can be changed after an
automatic selection as well.
1. Tap the following symbol on the data collection
screen.
All available programs will be displayed.
2. Tap the symbol for the desired program.
The balance weight positions will be updated.
The balancing program indicated in the status
bar will be updated.
Subsequently, the data collection screen will be
displayed directly.
en
symbol is
|
1 695 600 965
2020-02-27
Werbung
