Beissbarth MT ZERO 6 Touch Betriebsanleitung Seite 113

i
Follow the instructions on the monitor if applicable.
The software will respond directly to movement
of the electronic rim distance gauge and provide
immediate feedback to the user.
2. Position the electronic rim distance gauge that
measures the distance and diameter of the rim
on the rim flange and keep it in that position for a
second.
Fig. 63: Determining the 1st measurement point and 1st
balancing plane for Standard and ALU3
 An acoustic signal will confirm that the position
has been acquired.
Fig. 64: Display of the 1st measurement point on the monitor
i
If the electronic rim distance gauge is returned to
its rest position, the data collection screen will be
shown and the Standard balancing program will be
selected automatically.
For ALU2 and ALU3, proceed with the following
steps without moving the rim distance gauge to its
rest position.
Fig. 65: Selecting the standard program
Beissbarth GmbH
Wheel balancing | MT ZERO 6 Touch | 113
3. Position the electronic rim distance gauge at
the 2nd measurement point (without previously
moving the electronic rim distance gauge to its rest
position), and keep it in that position for 1 second.
Fig. 66: 2nd measurement point and 2nd balancing plane for
ALU3
2nd measurement point and 1st balancing plane for
ALU2
 An acoustic signal will confirm that the position
has been acquired.
Fig. 67: Showing the 2nd measurement point for ALU3
Fig. 68: Showing the 2nd measurement point for ALU2 on the
display
i
If the electronic rim distance gauge is returned to
its rest position, the data collection screen will be
shown and the ALU3 balancing program will be
selected automatically.
For ALU2, proceed with the following steps without
moving the rim distance gauge to its rest position.
en
ALU3
ALU2
651127-67_BM
|
1 695 600 965 2020-02-27