Beissbarth MT ZERO 6 Touch Betriebsanleitung Seite 101

4.9 Monitor connections
1. Remove the power supply cable of the monitor,
the DVI cable and the USB cable included in the
monitor's scope of delivery.
2. Insert the cables into the correct sockets on the
monitor.
Fig. 37: Connecting the cables to the monitor
3. Insert the cables into the mount and route them out
of the base.
Fig. 38: Inserting the cables into the mount
4. Connect the DVI cable and the USB cable to the
correct sockets on the connection plate.
Fig. 39: Connecting the DVI and USB cables
Beissbarth GmbH
Initial commissioning | MT ZERO 6 Touch | 101
5. Connect the power supply cable to the socket
shown here.
Fig. 40: Connecting the power supply cable of the motor
"
This concludes the connection of the motor.
4.10 Installing the clamping tool holders
¶
Use the screw set included in the scope of delivery
to install the holders as shown in the figure.
1
1
6,3x16
651127-39_BM
Fig. 41: Installing the clamping tool holders
en
|
1 695 600 965 2020-02-27