Beissbarth MT ZERO 6 Touch Betriebsanleitung Seite 143

Error Causes
ERROR 22 Irregular measurement sensor signals.
ERROR 27 Incorrect measurement of wheel width
ERROR 29 Rim-distance gauge/sonar not in rest position.
ERROR 30 Electronic rim-distance gauge/measurement sensor was
deactivated.
ERROR 31 Pedal being pressed. Deactivation takes place.
ERROR 32 Pedal has been pressed.
ERROR 33 Incorrect operating system!
ERROR 34 Software error
ERROR 37 Printer is not connected.
ERROR 38 Text idiom missing.
ERROR 39 Incorrect version of WINCE firmware for chosen
language.
ERROR 40 Emergency stop.
ERROR 42 Pneumatic flange is open
ERROR 43 Time for obtaining the wheel width data by the
measurement sensor expired.
ERROR 44 Wheel cover not opened completely
ERROR 60 Updating of the software for the WBU card failed.
Beissbarth GmbH
Faults | MT ZERO 6 Touch | 143
Remedy
Inform customer service.
Repeat measurement.
Move rim-distance gauge/sonar to rest position.
Inform customer service.
Avoid pressing the pedal during the measuring cycle.
Avoid pressing the pedal during the measuring cycle.
Inform customer service.
Inform customer service.
R Check whether the printer is switched on.
R Check that the cable is connected to the graphics
card.
R Check that the printer has no malfunctions during
normal operation.
Inform customer service.
The chosen language will be replaced with English.
Repeat the measuring cycle.
Close the pneumatic flange by pressing the pedal.
Repeat measurement.
Open wheel cover completely.
Inform customer service.
1 695 600 965
en
|
2020-02-27