Beissbarth MT ZERO 6 Touch Betriebsanleitung Seite 131

Outside rim flange (ALU3 1st balancing plane and
standard programs)
¶
A laser beam will be directed at the wheel. Attach the
balance weight at the center facing the indicator.
Fig. 109: Directing the laser beam at the rim flange
!
Calibrate the device before its first use and
subsequently according to the maintenance
schedule.
!
It is advisable to also calibrate the device whenever,
during the balancing process, a great number of
corrections is required for selecting and positioning
the balance weights.
i
For the calibrating process, see the "External laser
indicator calibration" section.
i
For attaching clip-on balance weights, see the
"Attaching clip-on balance weights" section.
Beissbarth GmbH
Imbalance minimization | MT ZERO 6 Touch | 131
9. Imbalance minimization
If the measured imbalance of the wheel is severe (e.g.
a static imbalance > 50 g), it is advisable to perform
an "Imbalance minimization".
The program allows for the minimization of the total
imbalance by compensating the static imbalance of the
tire with that of the rim.
!
Work as accurately as possible throughout the
procedure!
i
Follow the instructions on the monitor.
i
The program can be closed by tapping the
symbol.
i
In the following description, automatic start is
active.
Phase 1
1. Tap the symbol on the basic balancing screen
to activate the function.
 The first screen with instructions will be shown.
Symbols Description
After a tap on the symbol, the basic balancing
screen will be displayed and the OPT function will
not be continued.
By a tap on the symbol, the software will receive
confirmation that the corresponding process has
been carried out and the measuring cycle will start.
2. Close the wheel guard, and use the
confirmation.
 The measurement will start.
en
symbol for
|
1 695 600 965 2020-02-27