Beissbarth MT ZERO 6 Touch Betriebsanleitung Seite 126

en 126 | MT ZERO 6 Touch | Wheel balancing
8.12 Attaching clip-on balance weights
i
Use the balance weight pliers to locate the clip-on
balance weights.
Fig. 88: Balance weight pliers
1 Tip for removing the clip-on balance weight
2 Hammer for fastening the weight to the rim
3 Shears for cutting the adhesive balance weights
4 Groove for pressing in the clip-on balance weight
5 Blade for scraping the adhesive balance weights
1. Once the exact position for the balance weight has
been found, put the clip-on balance weight on the
edge of the rim.
2. Fasten the clip-on balance weight to the rim with the
hammer of the balance weight pliers (2).
Fig. 89: Attaching a clip-on balance weight
i
Use the tip (1) of the balance weight pliers to
remove the clip-on balance weight.
|
1 695 600 965 2020-02-27
8.13 Attaching the adhesive balance
weights
!
Use the plastic spatula to remove the adhesive
balance weight.
8.13.1 Overview of tools to be used
Position of
balance weight
Electronic
ok
ok
–
Tab. 4: Overview of tools to be used
8.13.2 With the electronic rim distance gauge
i
The electronic rim-distance gauge shown in the
following figure supports fastening the adhesive
balance weights in Alu2, Alu3 and Pax2 by stopping
when the balancing plane is reached. This function
does not support all of the standard programs.
Fig. 90: Electronic rim-distance gauge for fastening the adhesive
balance weights
i
The electronic rim-distance gauge shown in the
following figure does not support fastening the
adhesive balance weights in Alu2, Alu3 and Pax2.
In this case, it is necessary to position the adhesive
balance weights manually with the aid of the laser
indicator.
Fig. 91: Electronic rim-distance gauge not suitable for fastening
the adhesive balance weights
Rim-distance gauge
Manual
Rim bead Rim well
ok –
– ok
ok –
Beissbarth GmbH