Beissbarth MT ZERO 6 Touch Betriebsanleitung Seite 119

1. Position the slide with stop of the weight positioning
gauge (8) on the bead of the rim.
Fig. 81: Weight positioning gauge
1 Weight positioning gauge handle
2 Weight positioning gauge head
3 Inside balance weight holder
4 Ejector
5 Outside balance weight holder
6 Millimeter scale
7 Knurled screw
8 Weight positioning gauge slide with stop
2. Place the outside balance weight holder (5) on the
plane where the balance weights are to be attached.
Fig. 82: Determining the measurement for an adhesive balance
weight
3. Tighten the knurled screw (7) to lock the determined
position.
4. Read off the value "J" on the millimeter scale.
5. Tap the numerical value of the
show the numerical evaluation device.
6. Enter the read-off value.
7. Confirm the value entered to return to the data
collection screen.
"
All the necessary rim data have been recorded.
8.10 Measuring imbalance
i
A wheel can only be balanced correctly if all the
settings correspond to the mounted wheel.
Beissbarth GmbH
Wheel balancing | MT ZERO 6 Touch | 119
i
In the following description, automatic start is
active.
i
The measurement can be interrupted at any time by
pressing the STOP key.
1. Close the wheel guard.
 The balancing measurement will start automati-
 The following screen will appear.
i
If the Standard, ALU1 (PAX1), ALU4, ALU5 program
or any static balancing program is used, the rim
width will be acquired when the protective hood is
lowered for activation of start.
i
When the measurement is complete, the values for
the required balance weights will be shown on the
monitor.
i
By default, grams are set as the unit for the balance
weight values. The user settings menu can be used to
change to ounces.
2. Only open the wheel guard after the wheel has come
to a complete stop.
i
If the wheel imbalance measured is severe (e.g. a
static imbalance greater than 50 g), it is advisable
parameter to to carry out the optimization procedure that uses
the static imbalance of the rim to compensate for
the static imbalance of the tire (see "Imbalance
minimization" section).
i
With the non-standard programs (ALU2, ALU3,
Pax2), the function for splitting the balance
weights (split program) can be used to hide the
outside balance weight behind the spokes. (See
the "Splitting the balance weights (split program)"
section.)
cally if automatic start is set. If not, press START.
1 695 600 965
en
|
2020-02-27