Installation Of The Monitor - Sirona SIVISION 3 Installationsanleitung

5 Installation of the Monitor

5 Installation of the Monitor
A A
B
4.
M4x12
5.
M4
Flat washer
Contact washer
1. Unscrew the protective cover off from the monitor.
2. Tighten the two upper monitor screws a few turns into
the monitor (do not tighten completely).
3. Mount the monitor into the openings A of the support.
ATTENTION
The articulated arm of the monitor support contains a brake
adjusted to a high braking force! After the monitor has been
placed on the support arm, you must not grasp the monitor
and tilt it! Due to the lever action and the brake in the
articulated arm, this may cause the elongated holes in the
support to rip.
If you wish to tilt the monitor, you must use the articulated
arm or at least loosely tighten the lower screws B first.
4. Insert the lower screws B and tighten them slightly.
Completely tighten all four screws.
5. Attach the ground wire to the monitor at the position
marked with the grounding symbol.
10
3.
M4x12
2.
1.
6. The brake in the articulated arm is preadjusted at
the factory. The braking action must be adjusted using
the screw behind the left cover (as seen from the mon-
itor).
Fasten the cover.
Sirona Dental Systems GmbH
6.
Brake adjustment
59 14 200 D 3322
D 3322.031.11.04.02