Installing The Tray Support Arm For Monitor - Sirona SIVISION 3 Installationsanleitung

Sirona Dental Systems GmbH
4

Installing the Tray Support Arm for Monitor

6.
i
NOTE
The support tube H is always mounted on the inside of the
chair (Pos. 2 = right-handed version, Pos. 4 = left-handed
version, cf. diagram on 5).
In the left-handed version, the cables must be brought out
to the other side of the support tube. Disassemble the
D-Sub (Cannon) connector housing. Pull the cables
carefully back into the support tube and guide them back
out again to the other side.
Replace the connector housing.
Make sure there are no kinks anywhere along the
cables!
The description below refers to the standard configuration
(right-handed version).
1. Loosen the set screw B on support tube H.
2. Attach the support tube to the support arm shaft. The
support tube must be securely seated on ring D.
3. Align holes A and C with one another.
The graining on the ring D must be in line with the
hole A.
Fasten in this position with set screw B.
59 14 200 D 3322
D 3322.031.11.04.02
H
V
4.
4. Remove the trim cover V of the stop-out screen.
5. Place the rubber ring on the support tube.
6. Thread the cables of the support arm downward and
then outward through the elongated hole and then in-
sert the support tube in the hole.
ATTENTION
When running the cables, make certain they do not become
crushed or kinked.
4 Installing the Tray Support Arm for Monitor
Graining
2.
D
!
C
A
B
Installation of left-handed version
i
5.
Do not
use
3.
1.
7