Change Of Gear Oil - Rotax Rm 1 Benutzerhandbuch

4.14.

Change of gear oil

During the first 5 operating hours wear is highest. For this reason the gear oil must be changed
after the first 5 operating hours (and then after every 50 operating hours).
Proceed as follows:
Open the oil drain screw (pos. 2).
Collect the drained oil in a suitable container.
Note: Dispose of the old oil according to the
regulations of your country.
Clean the oil drain screw.
Fit the oil drain screw and tighten it with 20 Nm (177
lb. in.).
Open the oil refill screw (pos. 1).
Fill in 0,25 l (0.066 gal.) of motor oil of quality SAE 15 W 40.
Check the oil level at the inspection glass.
Hand tighten the oil refill screw (pos.1)
Attention: Never use the engine without motor oil,
this would damage the engine.
Seite/page 112/132
Operator`s Manual RM1
ROTAX KART RM1 Ausgabe/Edition 05/2003