Rotax RM 1 Benutzerhandbuch Seite 108

Note: The cuneiform washer (Pos. 4) is made of special plastic and has to be fitted
directly at the seat.
Proceed as per following drawing and use the parts specified:
Drill a bore of 8.5 mm / 3.4 in. diameter at the 3 positions marked.
Fasten the seat in these 3 positions.
th
Drill the 4 bore at the position left top (seen in driving direction).
Fasten the seat in this 4
Note: If you want to use the seat of another manufacturer pls. contact a ROTAX Service
Center.
Note: The seat fastenings screw have to be check regularly in the area of the upholstery
for type fit as the upholstery can sit after the first operating hours and the screw
tightening may loosen
Seite/page 108/132
Operator`s Manual RM1
th
position.
ROTAX KART RM1 Ausgabe/Edition 05/2003