Ignition System Peak Voltage - Yamaha WaveRunner FX160 Wartungshandbuch

– +
ELEC
IGNITION SYSTEM

IGNITION SYSTEM PEAK VOLTAGE

WARNING
When checking the electrical components,
do not touch any of the connections of the
digital tester lead wires.
NOTE:
• If there is no spark, or the spark is weak,
continue with the ignition system test.
• If a good spark is obtained, the problem is
not with the ignition system, but possibly with
the spark plug(s) or another component.
1. Measure:
• ECM output peak voltage
Below specification → Measure the
pickup coil output peak voltage.
Test harness (2 pins):
New: YB-06867
Current: YB-06767
Test harness FWY-2 (2 pins):
New: 90890-06867
Current: 90890-06767
ECM output peak voltage:
Black/red (B/R) –
Red/yellow (R/Y)
Black/white (B/W) –
Red/yellow (R/Y)
Black/yellow (B/Y) –
Red/yellow (R/Y)
Black/blue (B/L) –
Red/yellow (R/Y)
r/min
Cranking
V 87
NOTE:
• When measuring the ECM output peak volt-
age while cranking the engine, disconnect
the ignition coil couplers for all cylinders
except for the cylinder being measured.
• To crank the engine, connect the engine
shut-off cord (lanyard) to the engine shut-off
switch, and then press the start switch.
7-15
E
Loaded
2,000 3,500
86 85