Engine Oil Change - Using Oil Changer - Yamaha WaveRunner FX160 Wartungshandbuch

INSP
ADJ
POWER UNIT
• Remove the filler cap again and check
that the oil level is between the minimum
level mark a and maximum level mark
b on the dipstick.
• If the engine oil is below the minimum
level mark a, add sufficient oil of the rec-
ommended type to raise it to the correct
level.
• If the engine oil is above the maximum
level mark b, extract sufficient oil using
an oil changer to lower it to the correct
level.
NOTE:
If the oil temperature is low, the reading on
the dipstick will be low, and if the tempera-
ture is high, the reading on the dipstick will
be high.
Engine oil change — using oil changer
WARNING
Avoid changing the engine oil immediately
after turning the engine off. The oil is hot
and should be handled with care to avoid
burns.
CAUTION:
• Do not run the engine with too much or
not enough oil in the oil tank. Oil could
spray out or the engine could be dam-
aged.
• Do not run the engine for more than 15
seconds without supplying water, when
checking the oil level on land.
The engine could overheat.
• Be sure to change the engine oil after the
first 10 hours of operation, and every 100
hours thereafter or at the start of a new
season, otherwise the engine will wear
quickly.
1. Warm the engine up, and then put the
watercraft in a horizontal position.
3-18
E