Yamaha WaveRunner FX160 Wartungshandbuch Seite 626

– +
ELEC
1
1
REMOTE CONTROL SYSTEM
2
Diagnostic display
1. Check:
• Diagnostic display
Does not display → Replace the multi-
function meter.
Checking steps:
• Start the engine.
• Disconnect the coupler of a sensor (e.g,.
engine temperature sensor) that is nor-
mally displayed when a malfunction
occurs. Refer to "SELF-DIAGNOSIS" in
Chapter 9.
• Check that the check engine warning
indicator is displayed and that the buzzer
sounds.
• Press the select switch 1 for 8 seconds
and check the error code indicated on the
multifunction meter.
Checking the remote control transmitter
1. Check:
• Remote control transmitter
Does not operate → Replace the remote
control transmitter.
Checking steps:
CAUTION:
If the buttons on the remote control
transmitter are pushed but the transmit-
ter does not operate, the battery may be
low.
• Press the lock button 1 of the remote
control transmitter. The beeper sounds
once.
• Check that the "SECURITY" indicator
light goes off and the engine cannot be
started.
• Press the unlock button 2 of the remote
control transmitter for a short time. The
beeper sounds two or three times.
• Check that the "SECURITY" indicator
light comes on and the engine can be
started.
7-53
E