Troubleshooting - siat XL33-SP Bedienungsanleitung

12.9 TROUBLE SHOOTING
SITUAZIONE
When pressing the ON button, the
machine does not start.
The magnetothermic protection
opens the main switch.
Drive belts do not convey boxes.
Drive belts do not turn.
Drive belts break.
Squeaking noise as boxes pass
through machine.
Tape not centered on box seam.
Flap kicker kicks at wrong time.
The tape leg on the front of the
case is too long.
SMB00043K Rev. 0
CAUSA
The lockable emergency stop button is
pressed.
Short circuit in the electrical system.
Motor under stress.
Thermal cut-out not at correct amperage
setting.
Narrow boxes.
Worn drive belts.
Top taping head does not apply enough
pressure.
Taping head applying spring holder missing.
Taping head applying spring set too high
Worn or missing friction rings.
Drive belt tension too low.
Electrical disconnect.
Circuit breaker not at correct setting.
Motor not turning.
Worn belt.
Dry compression rollers.
Defective column bearings
Tape drum not centered.
Centering guides not centered.
Box flaps not of equal length.
Kicker cam improperly set
The tape is threaded incorrectly.
The tape tension is too low.
The knurled roller drags.
Tape tracks to one side or drags on the
support tabs of applying frame.
The one-way tension roller is not
correctly positioned.
Taping heads is not set up properly.
SM11-SP / XL33-SP
Release the emergency stop button.
Check the electrical system.
Check that the drive belts are not blocked.
Set the correct amperage.
Check machine specifications. Boxes are narrower
than recommended, causing slippage and
premature belt wear.
Replace drive belts.
Adjust the box height adjustment with the crank.
Replace spring holder.
Reduce spring pressure.
Replace friction rings.
Adjust belt tension.
Check power and electrical plug.
Set to correct current value.
Evaluate problem and correct
Replace belt.
Lubricate compression rollers.
Replace column bearings.
Reposition tape drum.
Adjust centering guides.
Check box specifications.
Reposition kicker cam.
The tape must go around the wrap roller
before going around the one-way tension
roller.
Adjust the one-way tension roller.
Check for adhesive build-up between
the knurled roller and its shaft. Clean and
lubricate shaft.
Remove all lubricate from roller surfaces.
Adjust the tape web alignment.
Position the roller in its mounting slot so that
the tape extends just beyond the center line
of the applying roller.
Check leg length adjustments.
85
RIMEDIO