Getting Into And Out Of The Power Wheelchair; From The Side; Fig. 17 Adjusting The Lower Leg Length - Otto Bock A200 Gebrauchsanweisung

INFORMATION
The footrest bar must not be pulled out of the holding de-
vice by more than 160 mm.
Fig. 17 Adjusting the lower leg length
6.2 Getting Into and Out of the Power Wheelchair
CAUTION
Risk of injury if the power wheelchair starts rolling.
When getting into or out of the power wheelchair, the
wheelchair controls must always be switched off. This will
automatically engage the motor brake.
A200
CAUTION
Risk of breakage due to overloading. The user must not
apply his or her entire body weight to the footrests and
armrests for support when getting into or out of the
wheelchair.
The modular design of the power wheelchair and the ease
with which you can remove the side panels and footrests
make it easy to get into and out of the wheelchair from the
side or from the front.
Getting into and out of the wheelchair can be done by the
user individually in a way that suits him or her best.
6.2.1 From the side
Getting into the wheelchair from the side requires the user to
remove the right or left side panel depending on the side where
the user will get into the wheelchair. Bring the power wheelchair
as close as possible to the place where its user is sitting.
If the control panel is on the side the user wants to use to
get into/out of the wheelchair, then undo the hook and loop
closures that fix the cable for the control panel to the
wheelchair and pull off the control panel. Remove the side
panel as described in section 6.1.3. If necessary, remove
the footrest (see section 6.1.5).
Operation
Ottobock 103
|