Getting Into And Out Of The Power Wheelchair; From The Side; Figure 12 Adjusting The Lower Leg Length - Otto Bock B600 Bedienungsanleitung

When making the adjustment, ensure that the
INFORMATION
footrest bar (item b) slides at least 60 mm into the swivel
segment (item c). After completing the adjustment, tighten
the set screw with a torque of 8 Nm.
Figure 12 Adjusting the lower leg length
B600
Downloaded from www.Manualslib.com manuals search engine
6.2

Getting Into and Out of the Power Wheelchair

CAUTION
Risk of injury if the power wheelchair starts rolling.
When getting into or out of the power wheelchair, the
wheelchair controls must always be switched off. This will
automatically engage the motor brake.
CAUTION
Risk of breakage due to overloading. The user must not
apply his or her entire body weight to the footrests and
arm rests for support when getting into or out of the wheel-
chair.
The modular design of the power wheelchair and the ease
with which you can remove the side panels and footrests
make it easy to get into and out of the wheelchair from the
side or from the front.
Users can get into and out of the wheelchair using their pre-
ferred and individual method.

6.2.1 From the Side

Getting into the wheelchair from the side requires the user to
remove the right or left side panel depending on the side
02/2009
Operation
Page 119