Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CHKSUM
FAIL
OFFSET
FAIL
PRINTER
FAILURE
ERROR ON DSB
ERROR ON RS232
C. SaO Messages
Message appears until
unit is turned
off. Self
test was not successful.
Message appears until
unit is turned
off. Self
test was not successful.
Message indicates a
problem with the
recorder mechanism.
Message indicates a
collision or data error on
the Datascope Serial Bus.
Message indicates a
collision or data error on
the RS232C Bus.
The following messages pertain to SaOz2 Operation.
Message
NO SENSOR
SENSOR OFF
INTERFERENCE
PULSE SEARCH"
WEAK PULSE
NO PULSE
PR UNDER 30
PR OVER 250
SAO2 UNCAL
CHECK SENSOR
FILTER
FAIL
Reason
Sensor not connected
to ACCUTORR.
Sensor not connected
to patient.
Patient motion.
ACCUTORR establishing
patient pulse level.
Low patient pulse
amplitude.
Patient pulse not
detected.
' Pulse rate below
operating limits.
Pulse rate above
operating limits.
SaO> value below
specified accuracy.
Sensor incorrectly
applied.
Defective
sensor.
System self test was
unsuccessful.
Power cycle unit.
Power cycle unit.
Message remains until
the situation is corrected.
Message remains until
a successful transmission.
Message remains until
a successful transmission.
Response
Connect sensor if desired.
Connect sensor to patient.
Wait for motion to end.
Wait or reposition sensor.
Check patient.
Check patient.
Check sensor site.
Power cycle unit.
'
x
1-26
Revised 03/13/91
Werbung
