Calibrate Control Stick - Reely HCP80 Bedienungsanleitung

15.

Calibrate Control Stick

For best control of the model helicopter, the path of the control sticks must be precisely recorded electronically. The
paths are set ex works but can be calibrated anew at any time. For this, the „ENGINEER" mode must be called.
• Push and hold the buttons „SELECT" and „INC (+)" and
switch on the transmitter with the buttons pushed.
• When the „ENGINEER" mode is displayed, release the but-
tons again.
Calibration starts with the right control stick „RIGHT STICK",
which must be deflected horizontally to the left „Hori axis
LEFT" to the stop. According to the stick path, the electro-
nically recorded movement value changes (lower right in the
display).
• When the right control stick has been deflected to the left to
the stop, save the value by pushing the buttons „INC (+)" and
„DEC (-)" at the same time.
• The display shows „SET OK".
• Push the button „DOWN" to then save the horizontal middle
position „Hori axis CENTER" of the right control stick.
• Move the control stick to the centre position and confirm the
two buttons „INC (+)" and „DEC (-)", to save the movement
value of the middle position.
• The display shows „SET OK".
• Push the button „DOWN" to save the right horizontal deflec-
tion „Hori axis RIGHT" of the right control stick.
• When the right control lever has been deflected to the right to
the stop, save the value by pushing the buttons „INC (+)" and
„DEC (-)" at the same time.
• The display shows „SET OK".
Figure 49
113