Reely HCP80 Bedienungsanleitung Seite 101

• Pushing the button „CLEAR" will call the set value specified ex works again.
The chart does not show the complete control characteristic curve. The left edge corresponds to the middle
position and the right edge to the max. deflection.
• Push the button „SELECT" so that the input function will jump down to the dual rate input value „DR" (bottom-most
display figure in screen 35).
• Pushing the buttons „INC (+)" or „DEC (-)" sets the described dual rate value for the roll servo. The lower the value
set, the lower the servo end deflection.
• The setting is saved automatically.
• Pushing the button „CLEAR" will call the set value specified ex works again.
• Push the toggle switch „Dual Rate" backwards towards the
body so that the display „AILE0" jumps to „AILE1" for reduced
deflection values.
• Programming of the dual rate and exponential values in this
setting works according to the same principle as in the large
deflections.
• When you have set all dual rate and exponential values for
the roll function, push button „SELECT" so that the display
„AILE0" or „AILE1" has a black background.
• Now use the buttons „INC (+)" or „DEC (-)" to switch to the
function „ELEV0"/"ELEV1" or „RUDD0"/"RUDD1" and also
set the dual rate and exponential values there according to
the same principle.
• Push the buttons „UP" and „DOWN" at the same time to re-
turn to the overview of the function setting menu.
Figure 36
Figure 37
101