Reely HCP80 Bedienungsanleitung Seite 72

In the backlit display (also see figure 1, item 11), first „H-6" is
the display briefly.
Then there are two short signal sounds, the LED (also see fi-
gure 1, item 21) lights up and the display shows the operating
display.
Attention!
If the toggle switches „Flight Mode" or „Throttle hold" and the control stick for the pitch and tail functions
„Thro.Stick" are in the wrong position, the corresponding warning note is displayed. The transmitter also
emits acoustic warnings in a quick sequence.
If the warning message „Thro.Stick" does not go out in spite of the correct position of the control stick for the
pitch and tail function, the wrong control stick mode is probably set in the system setting menu. For more
information about this, see chapter 13.
The operating display consists of the following elements:
1 Battery symbol
2 Transmitter voltage display
3 Model type symbol
4 Nod trim display (mode 2)
5 Model name
6 Timer display (with activated timer only)
7 Roll trim display (mode 2)
8 Tail trim display (mode 2)
9 Flight condition display
10 Memory
11 Pitch trim display (mode 2)
12 Modulation type „FHSS"
If the power supply is no longer sufficient for a faultless operation of the transmitter (less than 4 V), the LED
display flashes and the transmitter emits short alarms at regular intervals.
In this case, terminate flight operation of the model immediately and insert a new set of batteries in the
transmitter.
72
Figure 4b
Figure 5