Reely HCP80 Bedienungsanleitung Seite 83

Every operation of a button is confirmed by a short signal sound. The display shows the change of the tail
trimming at the trimming display (see figure 5, item 8).
If the button is pushed and held, the remote control will emit a quick sequence of signals and the trim display
will move sideways more quickly. The trim middle setting is indicated by a higher signal sound. The set value
for tail trimming is automatically saved and must be re-adjusted after each activation of the remote control.
Roll trimming:
If the helicopter tries to drift or tip to the right, reduce the speed until the helicopter is standing safely on its skids again.
Now push the trim button for the rolling function (also see figure 1, item 6) to the left several times.
Push the pitch stick carefully forward and check if the adjustment was sufficient. Repeat the procedure until the model
does not show any tendency to drift to the right.
If the helicopter tries to drift to the left, push the trim button for the rolling function to the right.
The display shows the change of the rolling trimming at the trimming display (see figure 5, item 7). The set
value is stored automatically.
Figure 18
83