K) Mixer Programming „Mix1" And „Mix2 - Reely HCP80 Bedienungsanleitung

k) Mixer Programming „MIX1" and „MIX2"
The remote control offers the option of mixing two control channels. In a flight model, the function is used often, e.g.
to also automatically generate an elevator deflection when extending the landing or spoiler flaps, so that the model
airplane does not change its horizontal flight position. For the helicopter model „HCP80", these mixers are not needed
and therefore need to be switched off.
Proceed as follows for mixer programming:
• Call the function settings menu.
• Select the menu item „MIX1" or „MIX2" with the buttons „UP"
or „DOWN".
• Activate the menu item with the button „SELECT".
The display shows the master and slave functions as well as
the setting values for the mixing shares and the offset value.
All displayed setting values should be set to „0" and the func-
tion of the mixer should be off (setting „SW: INH").
• Push the button „SELECT" to call the specific setting values
when required.
• Pushing the buttons „INC (+)" or „DEC (-)" permits changing
the setting value or the button „CLEAR" to call the factory
setting.
• Set all setting values to „0" and switch off the mixer (setting
„SW: INH"), if it is activated.
• The setting is saved automatically.
• Push the buttons „UP" and „DOWN" at the same time to re-
turn to the overview of the function setting menu.
110
Figure 46