The System Setting Menu „System - Reely HCP80 Bedienungsanleitung

13. The System Setting Menu „SYSTEM"
The basic settings of the remote control transmitter are made in the system setup menu first. These settings are not
referred to individual models. The specific settings of the individual models are only made afterwards in the function
setting menu (see chapter 14).
To get to the system setting menu, push and hold the two buttons „UP" and „DOWN" at the same time and switch on
the transmitter with the on/off switch.
When the system setting menu is displayed and the remote control makes two short confirmation sounds, release
the two buttons again.
The first 4 menu items of the system setting menu are now
displayed; see figure on the right.
The following setting functions are available to you in the system setting menu:
Function
Model name settings
Model memory selection
Copying model memory
Reset model memory
Model type selection
Control stick assignment
Calibrate pitch stick middle position
To leave the system setting menu again and to return to the operating system, push the two buttons „UP" and „DOWN"
at the same time again.
When you have called a menu item in the system setting menu, it is possible to switch right to the adjacent
menu item with the button „UP" or „DOWN", which then has also been called already without having to take
the detour across the menu item display.
Display
„1: MDL NAME"
„2: MDL SEL"
„3: MDL COPY"
„4: MDL RST"
„5: MDL TYPE"
„6: STK TYPE"
„7: STK ADJ"
Figure 22
87