The Function Setting Menu „Function - Reely HCP80 Bedienungsanleitung

14. The Function Setting Menu „Function"
The specific settings for the respective models are made in the function setup menu. The menu items available in the
function setup menu depends on which model type was selected in the system setup menu.
These instructions will only deal with the setting options that are relevant in connection with the helicopter
„HCP80".
The designations of the different control functions in the helicopter programming are partially assumed from the plane
model settings and have the following functions:
AILE = rolling function, ELEV = nodding function, THRO = throttle function, RUDD = tail function
To get to the function setting menu, switch the transmitter on
with the on/off switch. If the operating display appears, push the
two buttons „UP" and „DOWN" at the same time.
When the function setting menu is displayed, release the two
buttons.
The first 4 menu items of the function setting menu are now
displayed; see figure on the right.
The following setting functions are available for you in the system setting menu:
Function
Servo direction setting
Servo end deflection setting
Basic trim
Dual rate/exponential setting
Throttle switching
Gyro sensitivity setting
Throttle curve setting
Pitch curve setting
Swash plate servo settings
Pitch/tail mixer
Mixer programming
Mixer programming
Timer
Servo control/test
96
Display
„1: REVERSE"
„2: EPA"
„3: SUB TRIM"
„4: D/R"
„5: TH HOLD"
„6: GYRO SEN"
„7: TH CURV"
„8: PIT CURV"
„9: SWASH MIX"
„10: REVO MIX"
„11: MIX1"
„12: MIX2"
„13: TIMER"
„14: MONITOR"
Figure 31