G) Throttle Curve Setting „Th Curv - Reely HCP80 Bedienungsanleitung

g) Throttle Curve Setting „TH CURV"
For the throttle curve setting, you can change the linear control function specifically in 5 points (L, 1, 2, 3, and H) and
thus individually adjust it to your control habits or your requirements. The setting of the throttle curve can be made
separately for each flight condition („NOR" = normal, „IDLE1" and „IDLE2"). Thus, you are able to specify the motor
output for the respective pitch stick position for start, round flight or aerobatics.
To set the throttle curve, proceed as follows:
• Call the function settings menu.
• Select the menu item „TH CURV" with the buttons „UP" or
„DOWN".
• Activate the menu item with the button „SELECT".
The display shows the throttle curve for the flight condition
„NOR" (= normal).
• Pushing the buttons „INC (+)" or „DEC (-)" permits changing
the lowest value of the throttle curve „L". In parallel to this,
the control curve in the right chart changes. The two values
„I" and „O" show the input value (position of the pitch control
stick) and the output value by the deformed throttle curve.
• Pushing the button „CLEAR" will call the set value specified
ex works again.
• The setting is saved automatically.
• Push the button „SELECT" to select the next point on the
throttle curve (1). The position of points 1, 2 and 3 is indicated
by a dashed line.
• Pushing the buttons „INC (+)" or „DEC (-)" permits changing
this value of the throttle curve and tracking the change in the
figure.
• Then switch to point 2 with the button „SELECT" and set the
required value there as well.
• Repeat the process until you have set all 5 points on the
throttle curve for the flight condition „NOR".
104
Figure 40