Setting The Reverse Switches; Setting The Dual Rate Switch - Reely Mini Hawk Bedienungsanleitung

d) Setting the reverse switches
Should the rudders or the motor not respond as shown in
Figs. 21 - 23, you can change the running direction of each
individual channel.
This can be done by using four factory-set reverse switch-
es on the remote control (see also Figure 16, no. 11).
The switches are assigned the following functions:
1CH = aileron
2CH = elevator
3CH = motor function
4CH = rudder (without function)
These switches enable you to set the correct running di-
rection of the servos or the control function of the drive
motor if necessary.
e) Setting the dual rate switch
The dual rate switch (D/R) enables to reduce rudder de-
flections for the model to respond more smoothly to the
control commands from the transmitter.
The dual rate switch is a slide switch located on the left
side of the transmitter (see also Figure 15, no. 8).
If the switch is in the right position (100%), the servos and
thus also the rudders have the maximum deflection.
Setting the switch to the left position reduces the travel of
all servos to 70%.
Figure 24
Figure 25
67