Safety And Application Instructions - Siemens SINAMICS DCM Betriebsanleitung

Safety notes

1.2 Safety and application instructions

1.2 Safety and application instructions
This electrical equipment is used in industrial high-voltage installations. During operation,
this equipment contains rotating parts (fan) and live, bare parts. For this reason, it could
cause severe injury or significant material damage if the required covers are removed
without authorization, if the equipment is used or operated incorrectly, or if it has not been
properly maintained.
When the equipment is used in non-industrial areas, the installation location must be
protected against unauthorized access (e.g. protective fencing).
NOTICE
In a residential environment this product can cause high-frequency disturbances, which
may make interference suppression measures necessary.
In the cabinet, the main circuit is not always protected against direct contact.
Touching live parts can result in death or serious injury.
Before opening the cabinet, ensure that all main circuits are completely switched off on all
sides, and all phases are locked out to prevent reclosure and are grounded.
Preconditions
Those responsible for protecting the plant must ensure the following:
● The basic planning work for the plant and the transport, assembly, installation,
commissioning, maintenance, and repair work is carried out by qualified personnel and/or
checked by experts responsible.
● The operating instructions must always be available for all of the work that is performed.
● The technical data and specifications regarding the permissible installation, connection,
environmental and operating conditions are always consequentially observed.
● The country-specific and plant-specific installation and safety guidelines are observed
and personal protection equipment is used.
● Unqualified personnel are forbidden from using this equipment and working near this
equipment.
These Operating Instructions are intended for qualified personnel and only contain
information and notes relating to the intended purpose of the equipment.
16
DANGER
WARNING
Operating Instructions, 04/2015, A5E36161239/RS-AA/001
SINAMICS DCM Cabinet