G60, Customer Terminal Block Extension Using A Terminal Module Tm31 - Siemens SINAMICS DCM Betriebsanleitung

11.8.2

G60, customer terminal block extension using a Terminal Module TM31

Category
Supplementary modules
Function
Customer terminal expansion module TM31
The following are located on the TM31 Terminal Module:
● 8 digital inputs
● 4 bidirectional digital inputs/outputs
● 2 relay outputs with changeover contact
● 2 analog inputs
● 2 analog outputs
● 1 temperature sensor input (KTY84-130 or PTC)
A detailed description is provided in the operating instructions for SINAMICS DCM DC
Converter and in Catalog D 23.1.
Note
For this option, an Advanced CUD with DRIVE-CLiQ port (G00, G11) and a 24 V DC power
supply (L06, L07 or L09) are required.
Connection
The connection is made directly at the TM31 Terminal Module. Description of the
connections, see Catalog D23.1.
Commissioning
See the operating instructions of the SINAMICS DCM DC converter, List Manual of the
SINAMICS DCM DC converter, operating instructions of the SINAMICS DCM Cabinet,
Chapter Signal connections (Page 85).
Cable routing
The cables are routed into the cabinet corresponding to the following diagrams.
SINAMICS DCM Cabinet
Operating Instructions, 04/2015, A5E36161239/RS-AA/001
Options
11.8 Supplementary modules
283