Supplementary Modules; G51, Customer Terminal Block Extension Using A Tm150 Terminal Module - Siemens SINAMICS DCM Betriebsanleitung

Options

11.8 Supplementary modules

11.8 Supplementary modules
11.8.1

G51, customer terminal block extension using a TM150 Terminal Module

Category
Supplementary modules
Function
Function:
Customer terminal strip extension TM150 for temperature sensor evaluation
The TM150 Terminal Module can be used to evaluate the following temperature sensors:
● PT100 (with monitoring for wire breakage and short-circuit)
● PT1000 (with monitoring for wire breakage and short-circuit)
● KTY84 (with monitoring for wire breakage and short-circuit)
● PTC (with monitoring for wire breakage and short circuit)
● Bimetallic NC contact (without monitoring)
A detailed description is provided in the operating instructions for the SINAMICS DCM
DC converter and in Catalog D 23.1.
Note
For this option, an Advanced CUD with DRIVE-CLiQ port (G00, G11) and a 24 V DC power
supply (L06, L07 or L09) are required.
Connection
The connection is made directly at the TM150 Terminal Module. Description of the
connections is provided in Catalog D23.1.
Commissioning
See the operating instructions of the SINAMICS DCM DC converter, List Manual of the
SINAMICS DCM DC converter, operating instructions of the SINAMICS DCM Cabinet,
Chapter Signal connections (Page 85).
Cable routing
The cables are routed into the cabinet corresponding to the following diagrams.
280
Operating Instructions, 04/2015, A5E36161239/RS-AA/001
SINAMICS DCM Cabinet