Siemens SINAMICS DCM Betriebsanleitung Seite 371

Item Activity
31 Option G60
Customer terminal
block TM31
32 Option G62
Customer terminal
block TM15
33 Option K50
Sensor Module
Cabinet-Mounted
SMC30
SINAMICS DCM Cabinet
Operating Instructions, 04/2015, A5E36161239/RS-AA/001
The TM31 Terminal Module is used to expand the customer
terminals. This means that the following
additional interfaces are available:
8 digital inputs
•
4 bidirectional digital inputs/outputs
•
2 relay outputs with changeover contact
•
2 analog inputs
•
2 analog outputs
•
1 temperature sensor input (KTY84-130/PTC)
•
Integration of the interfaces takes place using pre-
interconnections prepared in the factory, which can be
selected during commissioning.
When the analog inputs of the TM31 are used as current or
voltage inputs, ensure that selector switches S5.0 and S5.1
are set accordingly.
See the operating instructions SINAMICS DCM DC convert-
er, Chapter 7.
Depending on the options, these inputs and outputs are used
internally and are therefore not all available to the customer.
See the specific circuit diagram of the purchased system for
the actual use.
The TM15 Terminal Module is used to expand the customer
terminals.
The following additional interfaces are available:
24 bidirectional digital inputs/outputs in 3 mutually isolat-
•
ed groups of 8 DI/O
Depending on the options, these inputs and outputs are used
internally and are therefore not all available to the customer.
See the
specific circuit diagram of the purchased system for their
actual use.
See SINAMICS DCM DC Converter Operating Instructions,
Chapter 7.
The SMC30 Sensor Module can be used to record the speed
and for position detection.
The following encoders are supported by the SMC30 Sensor
Module in conjunction with SINAMICS DCM:
TTL encoder
•
HTL encoder
•
SSI absolute encoder
•
The motor temperature can also be recorded using KTY84
130.
When supplied, an pulse HTL encoder is set bipolar with
1024
pulses per revolution.
See SINAMICS DCM DC Converter Operating Instructions,
Chapter 7.
Electrical installation
4.2 Checklist for electrical installation
Yes
☑
☐
☐
☐
Completed
☑
☐
☐
☐
59