Siemens SINAMICS DCM Betriebsanleitung Seite 572

Options
11.6 Motor-relevant options
Connection
Table 11- 20 Terminal strip –X3 – connection for motor fan 2
Terminal
6
7
8
PE
Max. connectable cross-section: 4 mm²
Commissioning
The motor circuit breaker is set by the customer on the plant side. The setting must be
documented in the system-specific circuit diagram when commissioning the system.
Cable routing
The cables are routed into the cabinet corresponding to the following diagrams.
260
Designation
L1
L2
L3
PE
Operating Instructions, 04/2015, A5E36161239/RS-AA/001
Technical data
Feeder, motor fan 2
PE protective conductor
SINAMICS DCM Cabinet