Siemens SINAMICS DCM Betriebsanleitung Seite 318

Preface
● SINAMICS DCM List Manual
The List Manual consists of the following sections:
– Parameter list
– Function diagrams
– Fault / warning list
● Free function blocks manual
● Documentation for Drive Control Chart (DCC)
– Programming and Operating Manual: DCC Editor description
– Function Manual: Description of the standard DCC blocks
The individual device documentation describes precisely one customized system and
contains the following:
● Dimension drawing
The dimension drawing documents the dimensions of the ordered system.
● Layout diagram
The components installed in the ordered system are displayed in the layout diagram with
the equipment codes and location codes.
● Circuit diagram
The circuit diagram displays the electrical components installed in the ordered system
including the equipment codes and location codes, their interconnections and the
customer interfaces.
● Terminal diagram
The terminal diagram shows all the customer terminals of the ordered system and the
associated internal cabinet wiring. This diagram documents the line-side target wiring.
● Parts list
All of the available spare parts for the ordered system are listed in the parts list with the
equipment codes, the location codes and the order designation.
● Additional Operating Instructions
The instructions for OEM components installed in the ordered system are supplied as
OEM documentation.
Service
You can find information on our services and regional contact persons in the Internet -
(https://support.industry.siemens.com/sc/ww/en/sc)
Technical Support
You can obtain technical assistance for products, systems, and solutions from our Technical
support (www.siemens.com/automation/support-request)
6
Operating Instructions, 04/2015, A5E36161239/RS-AA/001
SINAMICS DCM Cabinet