Siemens SINAMICS DCM Betriebsanleitung Seite 544

Options
11.5 Supplementary circuits
Commissioning
The temperature controller must be set when commissioning the system, so that under the
prevailing ambient conditions, condensation inside the cabinet is, as far as possible,
prevented.
Parameter assignment
The setting when delivered is 10 °C.
The switching difference is approx. 1 °C.
Diagnostics
The signaling contact of miniature circuit breaker =D5-F23 is included in the group fault
signal, circuit breaker tripped.
Cable routing
The cables are routed into the cabinet corresponding to the following diagrams.
232
Operating Instructions, 04/2015, A5E36161239/RS-AA/001
SINAMICS DCM Cabinet