Safety Instructions - HBM CMD Serie Bedienungsanleitung

1

Safety instructions

CMD
Appropriate use
The device is to be used exclusively for measurement
tasks and directly related control tasks within the applica­
tion limits detailed in the specifications. Use for any pur­
pose other than the above is deemed to be non‐desig­
nated use.
Any person instructed to carry out installation, commis­
sioning or operation of the device must have read and
understood the Operating Manual and in particular the
technical safety instructions.
In the interests of safety, the device should only be oper­
ated by qualified personnel and as described in the Oper­
ating Manual. It is also essential to comply with the legal
and safety requirements for the application concerned
during use. The same applies to the use of accessories.
The device is not intended for use as a safety compo­
nent. Please also refer to the "Additional safety precau­
tions" section. Proper and safe operation requires proper
transportation, correct storage, siting and mounting, and
careful operation.
Operating conditions
S Protect the device from direct contact with water.
S Protect the device from moisture and weather such as
rain or snow. To comply with the degree of protection
under the DIN EN 60529 standard, all the cables must
be connected and any connectors not in use must be
fitted with protective caps
S Do not expose the device to direct sunlight
A2781-3.1 HBM: public
Safety instructions
5