Safety Instructions - HBM AED Serie Kurzanleitung

15
Quick Start Guide – Digital transducer electronics AED-System

Safety instructions

In addition to the instructions below, please note and comply with the de-
tailed safety information and specifications in the individual device docu-
mentation.
Important notes
The device must not be modified from the design or safety engineering point of
view except with our express agreement. Any change shall exclude all liability
on our part for any damage resulting therefrom.
Repair is specifically forbidden. Repairs must only be carried out by HBM.
All the factory defaults are stored at the factory where they are safe from power
failure and cannot be deleted or overwritten. They can be reset at any time by
using the command TDD0.
The production number set at the factory must not be changed.
The transducer connection must always be assigned. It is essential for a
bridge model to be connected up for operation.
General dangers of failing to follow the safety instructions
The HBM components in the measurement chain are state-of-the-art and
fail-safe. The components can give rise to remaining dangers if they are
inappropriately installed and operated by untrained personnel.
Everyone involved with the installation, commissioning, maintenance or repair
of the components must have read and understood the Operating Manual and
in particular the technical safety instructions.
There are not normally any hazards associated with this product, provided the
notes and instructions for project planning, assembly, appropriate operation
and maintenance are observed.
It is essential to comply with the safety and accident prevention regulations
specific to the particular application.
Installation and start-up must only be carried out by suitably qualified person-
nel.
Do not allow the devices to become dirty or damp.
During installation and when connecting the cables, take action to prevent
electrostatic discharge as this may damage the electronics.
The required power supply is an extra-low voltage with safe disconnection from
the mains.
When connecting additional devices, comply with the safety requirements for
electrical measurement, control, regulatory and laboratory equipment
1)
(EN61010 ).
A1195-2.0 de/en/fr/es HBM