Software For Parameterizing The Cmd - HBM CMD Serie Bedienungsanleitung

Software for parameterizing the CMD

9 Software for parameterizing the CMD
50
You can implement the following settings with the "CMD
Assistant" software:
S Enter the sensitivity and measuring range of the chan­
nel.
S Chose the operating mode of the charge amplifier
(RESET/MEASURE).
S Chose the display option: measured value, min.,
max., peak‐to‐peak.
S Scale the analog output signal.
S Use SensorTeach for automatic scaling.
S Set the low‐pass and high‐pass filter options.
S Specify the functionality of the digital input and the
digital outputs.
S Select parameter sets in the device.
S Save parameter sets (settings) to the PC and load
them from the PC to the CMD.
S Record measured values on the PC.
S Start a stripchart and record measurement to the PC
(Host).
S Load and analyze measurements from a file.
All the settings are stored power failsafe in the CMD.
Data can also be loaded into the CMD Assistant and
modified if necessary, for offline parameterization of the
CMD.
A2781-3.1 HBM: public
CMD