Sensor Connection - HBM CMD Serie Bedienungsanleitung

Device description
green/blue, flashing
blue, constant
yellow, flashing at
1 Hz
yellow, flashing at
2 Hz
white, flashing at
2 Hz
red, flashing at 1 Hz Bootloader mode
blue/yellow/red/
green successively,
at 2 Hz
1)
Even if the IP addresses of the PC (Host) and the charge amplifier are in the same network
segment, the LED flashes green‐blue
22
IP address not configured
Connection via Ethernet
SensorTeach function in the
600000 pC range
(CMD600 / CMD600-P)
2000000 pC (CMD2000)
SensorTeach function in the
6000 pC range
(CMD600 / CMD600-P)
20000 pC (CMD2000)
Ready for a firmware update Bootloader is loaded. Once the
Interface connections active
7.3

Sensor connection

The CMD has a charge input (measurement channel) to
which piezoelectric sensors can be connected. All piezo­
electric sensors that generate max. 600000 pC
(CMD600/CMD600-P) or 2000000 pC (CMD2000). IEPE
sensors cannot be operated (see Chapter 14 "Tips for
piezoelectric measurement technology").
A2781-3.1 HBM: public
The device IP address is the fac­
1)
tory setting
The charge amplifier is ready to
measure and a PC (Host) is con­
nected via Ethernet.
SensorTeach is activated, the
device is in the large range.
SensorTeach is activated, the
device is in the small measuring
range.
"SensorTeach" input has first
been briefly set to the High level,
you have ten seconds to start
updating the firmware.
The device waits for PC input to
start the updating the firmware
(Update); the entry must be
made within 10 seconds.
Use this function to identify the
device currently connected via
the interface.
CMD