HBM CMD Serie Bedienungsanleitung Seite 62

Updating the firmware (Update)
60
The program starts to transfer the data to the device.
Progress is shown in the program window: Connect­
ing / Connected / 0 / CMD successfully updated
and in Progress (progress displayed as a bar).
- Close the program once the update is complete.
The CMD automatically returns to measuring mode.
- Reset the original IP address in your PC.
Tip
In order to simplify connection setup and address setting
during the firmware update, a second network card can
be used (also externally via USB).
A2781-3.1 HBM: public
CMD