Global garden products 72 Serie Kundendienst Handbuch Seite 98

<= ...BACK... <= WORKSHOP MANUAL
72
1998
••••
4.6.
from to
0
ALIGNING THE CUTTING DECK
2 / 2
page
Having checked that the rod has no possibility of longitudinal movement, tighten the locknut (6).
Screw down the nut (7) of the transverse adjuster until the front left begins to rise, and then tighten the lock-
nut (8).
B) Adjusting the parallel across the cutting deck alone
Any difference in height from the ground between the left and right sides of the deck can be compensated by
turning the nut (7) and the locknut (8) at the front left coupling point.
NOTE
Remember to tighten all the nuts and locknuts once these adjustments have been made, leaving the neces-
sary free rotation movement to the pins [see 2.6.B].
© by GLOBAL GARDEN PRODUCTS 3/2002