Global garden products 72 Serie Kundendienst Handbuch Seite 127

<= ...BACK... <= WORKSHOP MANUAL
72
1998
••••
6.6. - REPLACEMENT OF THE SUPPORT
from to
0
AND SHAFT OF THE BLADE
2 / 2
page
Fit on the upper bearing and, using the special bush
(13) which works on the inner ring, hit it squarely
with a mallet until the bearing is fully driven home.
12
Fit the flange support onto the deck, fully tighten-
ing the nuts (5).
4
13
4
Tightening torques
3 Blade pulley screw. .......................... 25 ÷ 30 Nm
5 Nuts for flanged support .................. 25 ÷ 30 Nm
© by GLOBAL GARDEN PRODUCTS 3/2002