Replacement Of Steering Components - Global garden products 72 Serie Kundendienst Handbuch

<= ...BACK... <=
REPLACEMENT OF THE STEERING COMPONENTS
6.3 REPLACEMENT OF THE STEERING
COMPONENTS
A) Dismantling the pinion and the ring gear
u Follow the same procedure as that for adjusting
free play [see 4.7].
B) Dismantling the steering shaft
After having dismantled the pinion and the ring gear
as described at point "A", take out the snap ring (1)
from its seat in the shaft (2) and extract the shaft
from the bushings (3) pulling it downwards.
After having refitted all the components it will be
necessary to ...
u Adjust the free play between the pinion and the
ring gear [see 4.7], remembering that with a new
pinion and ring gear it is not necessary to insert
spacers in-side the hub.
u Check the toe-in and the alignment of the steer-
ing wheel [see 4.8].
© by GLOBAL GARDEN PRODUCTS
WORKSHOP MANUAL
6.3.
0
from
page
2
1
3
72
1998
••••
to
1 / 1
3/2002