Replacement Of Tyres And Wheels - Global garden products 72 Serie Kundendienst Handbuch

<= ...BACK... <=

REPLACEMENT OF TYRES AND WHEELS

6.1 REPLACEMENT OF TYRES AND WHEELS
A) Tyres
The tyres used are of the «Tubeless» type and so
every repair of a hole in the tyre must be done by a
tyre specialist according to the methods used for
this type of tyre.
After replacing one or more tyres or the wheels, it is
always necessary to check the pressure and to
check the alignment of the cutting deck [see 4.6].
WARNING
Replace distorted wheel rims as they could impair
the tyre's hold.
B) Wheels
The wheels are held by a snap ring (1) which can be
removed with the help of a screwdriver.
NOTE
If a wheel is jammed onto the shaft, use a releasing
spray directed around the splining hole.
On assembly it is advisable to spread grease on the
shaft to facilitate the next wheel removal.
For the front wheels: replace the shoulder washer
(2) and the flexible ring (1) with the bevel facing
inwards.
For the rear wheels: replace the shoulder washer
(2) and the flexible ring (1) with the bevel facing
inwards and check the axial gap of the wheel on the
shaft; if it is greater than 3 mm, a spacer (3) must be
fitted between the wheel hub and the shoulder
washer (2).
Tyre pressures
Front ........................................................... 1.5 Bar
Rear ........................................................... 1.0 Bar
© by GLOBAL GARDEN PRODUCTS
WORKSHOP MANUAL
6.1.
1
72
1998
••••
from to
1 / 1
page
1
2
3
2
1
4/2007