Removal Of The Rear Axle (Peerless Lth 2000-004C) - Global garden products 72 Serie Kundendienst Handbuch

<= ...BACK... <=
5.7b.
3
5.7b REMOVAL OF THE REAR AXLE
(Tuff Torq K46T)
The rear axle (Transaxle) is made up of single
maintenance-free sealed unit which includes the
transmission unit (hydrostatic) and the differential.
It only needs to be removed to be replaced or for
an overhaul by the Manufacturer's Service Centre.
u Lift the wheels cover [see 2.5].
u Dismantle the engine pulley [see 5.5] to release
the belt.
Place two spacers (1) of approximately 150 mm
under the two ends of the rear plate.
u Remove the rear wheels [see 6.1].
Dismantle the pin (2) of the brake rod. It is best to
also loosen the transmission belt. This is done by
moving the stretcher's idle pulley (3) to the right.
Disconnect the drive engagement control rod (9) by
pulling out the split pin (10).
Disconnect the lever (12) drive release control rod
(11).
Disconnect the electrical connections of the "neu-
tral" signaler (21) and release the pulley (14) from
the belt (15).
The unit is supported by one or two brackets (18) –
© by GLOBAL GARDEN PRODUCTS
WORKSHOP MANUAL
- REMOVAL OF THE REAR AXLE
(Peerless LTH 2000-004C)
1
2
10 9
72
2004
••••
from to
1 / 2
page
3
21
4/2007