Global garden products 72 Serie Kundendienst Handbuch Seite 107

<= ...BACK... <=
REMOVAL OF THE WHEELS COVER
5.3 REMOVAL OF THE WHEELS COVER
Removing the wheels cover may be necessary for:
– improving access around the engine,
– removing the rear plate.
Unscrew the lever knob (2).
Take out the split pin (3) and remove the pin (4) to
dismantle the seat.
Release the spring (5) of the fixed cover of the
grass-catcher (6), by undoing the screws (7) which
hold on the small plate (8).
Undo the two self-threading screws (9) and loosen
the two screws (10) with nuts that hold the cover
onto the rear plate.
u Lift the wheels cover [see 2.5].
Undo the six screws which attach the tubular ele-
ment. Two of them are short (11) and four are longer
(12) and they can be reached from below.
When reassembling, do not forget to reattach the
connector (3) of the seat microswitch and to make
sure it works.
u Close up the wheels cover [see 2.5].
Tightening torques
9-11-12 Self-threading screws for wheels cover 6,5 Nm
10 M6 screws for wheels cover ............ 8 ÷ 10 Nm
6 9
© by GLOBAL GARDEN PRODUCTS
WORKSHOP MANUAL
5.3.
2
10
4
8
5
11
12
72
2003
••••
from to
1 / 1
page
2
3
7
6
4/2005