Replacement Of The Drive Lever Unit ( ➤ Hydrostatic Drive Models) - Global garden products 72 Serie Kundendienst Handbuch

<= ...BACK... <= WORKSHOP MANUAL
72
2004
••••
6.9.
from to
1
REPLACEMENT OF THE DRIVE LEVER UNIT
1 / 2
page
6.9 REPLACEMENT OF THE DRIVE LEVER UNIT
( ➤ Hydrostatic drive models)
u Lift up the wheels cover [see 2.5].
u Remove the collector channel [see 5.5]
2 1
With the pedal released, detach the rod (1) con-
necting to the rear axle by unscrewing the nut of the
3 4
pin (2), and the rod (3) connecting to the pedal by
unscrewing the nut of the pin (4).
Unhook the barrel (5) and detach the return cable
(6). 6
Unscrew the two screws (11) and remove the sup-
port (10) with the whole lever unit.
The whole unit is available as a spare part in a single
assembly unit.
5
Fit the new unit keeping it to the right, fixing it using
the two screws (11).
10
Hook the barrel (5) of the cable (6) and refit the pins
(2) and (4) without fully tightening their nuts, and
after having loosened the adjuster nuts of the rods
(1) and (3).
11
Check that the end (12) of the hook is positioned in
a way that does not impede the lever's (13) travel
and that it stops the movement of the lever (14).
16
14
If necessary, only loosen the back screw (15) and
move the terminal (12) just enough to achieve the
15
condition described above.
If you accidently loosen both screws (15) and (16),
thus losing their original position, you need to ....
13 12
u Adjust the stop [see 4.5.E].
© by GLOBAL GARDEN PRODUCTS 4/2005