Removal Of The Cutting Deck - Global garden products 72 Serie Kundendienst Handbuch

<= ...BACK... <=

REMOVAL OF THE CUTTING DECK

5.8 REMOVAL OF THE CUTTING DECK
Removing the cutting deck facilitates all the over-
haul and replacement of hubs, bearings and blade
shafts.
With some practice and experience it is possible
to do this work with the deck still in position.
Pull out the external split pin (1) through the inspec-
tion hole in front of the seat and remove the pin (2)
from the inside, in order to disconnect the collector
channel (3).
Bring the cutting deck to position «1» and put a
40 mm block underneath the rear right wheel.
Pull out the split pin (4) in order to disconnect the
entire bracket (5) from the blade engagement lever
(6).
➤ In mechanical drive models: slide the two
belt shifter bushes (7) up until the belt (8) is
released from the engine shaft pulley (9).
➤ In hidrostatic drive models:
u Dismantle the engine pulley
release the belt.
Unscrew the nut (10) in order to pull the pin (11) out
of the front left lifting lever (12).
Pull the elastic split pin (13) of the pin (14) in the rear
right lever (15) and the elastic split pin (16) fastening
the pin to the front right lever (17).
Take care not to touch the nuts and lock-nuts so
that they remain aligned for assembly
12 11
© by GLOBAL GARDEN PRODUCTS
WORKSHOP MANUAL
5.8.
1
[see 5.6] to
10 13 15
8 7
14
17
72
2003
from
page
1
2
3
5 6
7
9
16
••••
to
1 / 2
4
3/2003