Removal Of The Engine - Global garden products 72 Serie Kundendienst Handbuch

<= ...BACK... <=

5.6 REMOVAL OF THE ENGINE

Since there are different types of drive, the stages
described here refer to those shared or similar in
all types of engine.
u Turn back the wheels cover [see 2.5].
Disengage the blade to loosen the belt. The trans-
mission belt should also be loosened.
This is done by ...
➤ In mechanical drive models: engaging the
parking brake.
➤ In hydrostatic drive models: releasing the
spring (1) of the stretcher.
Undo the central screw (2) and take out the pulley
(3) from the shaft.
If it is difficult to take out, use the special extractor
inserted into the holes (4) of the pulley, but do not
completely undo the screw (2) so that the extractor
puts pressure on the head of the screw and does
not damage the threaded hole of the shaft.
Remove the protection from the exhaust (5) (differ-
ing according to the types of engine), and discon-
nect the accelerator cable control and all the electri-
cal wires.
Close the fuel cock and detach the fuel pipe, taking
care not to spill fuel.
Find and undo all the screws holding the engine to
the frame, grip the engine firmly and lift it, taking the
necessary care bearing in mind that its weight is
around 25 - 35 kg.
NOTE
Some types of engine are held with screws of differ-
ent lengths and in different positions, so it is best to
label them so that no errors are made when
reassembling.
© by GLOBAL GARDEN PRODUCTS
WORKSHOP MANUAL
5.6.
1
REMOVAL OF THE ENGINE
1
4 2
5
72
2004
••••
from to
1 / 2
page
3
4/2005